Leakage

2021-06-18

Probable Cause
l the pressure of entrance side over the machine limit.

l the junction part screws didn’t tighten 

l the  surface of mounting surface is irregularity.

l Assembly is not in place or sealer damage.

Remedy
l Check extruder settings, Have damaged or stress test error pressure sensor need to be replaced or make recalibration

l heating it and re-tighten the screws, Should use uniform torque

l to re-clean the surface, if it is necessary, planish with the millstone

l Check the installation location of parts, tighten the screws evenly, or replace a new sealer

Read more!